Til Ting Disc Check Valve
• Til Ting Disc Check Valves are used to prevent reversal of flow in horizontal or vertical pipe lines. In vertical pipe lines or any angle from
horizontal to vertical. They can be used for upward flow only. Til ting Disc Check Valves are similar to Swing Check valves. In most installations, slamming is minimized upon reversal flow. So, noise and vibrations are reduced.
SALIENT FEATURES:
• Til Ting Disc Check Valves consists of a cylindrical housing, with a pivoted circular disc. The pivots are located just above the center of the disc and offset from the plane of the body seat. This design gives a bell – crank action to the disc. The seat is circular bevel type and the disc drops in out of contact without rubbing or sliding.
• Short distance of travel, combined with a balanced disc allows rapid closure while minimizing slamming.
• Pivot pins are constructed of a Stainless Steel.
• Drop tight seating is accomplished over the full pressure range because a slight clearance at the pivot pin assures complete seating between the disc ring and body ring.
• The full flow area with lower head loss ensure with the highest efficiency and durability.
• Meet design requirements as per API 6D / API 594 / BS-EN 12334 / API B 16.34.
• Meet Inspection requirements as per API 598 / API 6D.
• Face to Face dimensions as per API 6D / API 594 / ANSI B 16.10.
• Flanged Ends to ANSI B 16.5 / B 16.47.
• Size Range: 4”NB to 20”NB.
OPTIONS:
• Single Switch / Hydraulic Cylinder (top, bottom and side mounted) design available on request.
• By – Pass arrangement available on request.
APPLICATION:
• Suitable for all types of water, air and steam 121°C or 250°F (For higher temperature, consult factory).